Ubuntu Utopic Installation Guide: Difference between revisions

From cchtml.com
No edit summary
Line 32: Line 32:
=== Download the latest Catalyst package ===
=== Download the latest Catalyst package ===
This package contains both the 32-bit and 64-bit driver.
This package contains both the 32-bit and 64-bit driver.
  mkdir catalyst{{Catalystversion}} && cd catalyst{{Catalystversion}}
 
  wget <nowiki>--referer='http://support.amd.com/en-us/download/desktop?os=Linux+x86' http://www2.ati.com/drivers/linux/amd-catalyst-omega-</nowiki>{{Catalystversion}}-linux-run-installers.zip
  mkdir catalyst15.7 && cd catalyst15.7
  unzip amd-catalyst-omega-{{Catalystversion}}-linux-run-installers.zip
  wget <nowiki>--referer='http://support.amd.com/en-us/download/desktop?os=Linux+x86' http://www2.ati.com/drivers/linux/amd-driver-installer-15.20.1046-x86.x86_64.zip</nowiki>
  unzip amd-driver-installer-15.20.1046-x86.x86_64.zip


=== Create and install .deb packages ===
=== Create and install .deb packages ===
If you have Wine installed, the driver installation may fail due to a conflict with a library included with Wine. In this case you'll need to [[#fglrx-core_conflicts_with_libopencl1| modify the fglrx-core package]] before executing the second command below.
If you have Wine installed, the driver installation may fail due to a conflict with a library included with Wine. In this case you'll need to [[#fglrx-core_conflicts_with_libopencl1| modify the fglrx-core package]] before executing the second command below.


  sudo ./fglrx-14.501.1003/amd-driver-installer-14.501.1003-x86.x86_64.run --buildpkg Ubuntu/utopic
  chmod a+x amd-driver-installer-15.20.1046-x86.x86_64.run
sudo ./amd-driver-installer-15.20.1046-x86.x86_64.run --buildpkg Ubuntu/trusty
  sudo dpkg -i fglrx*.deb
  sudo dpkg -i fglrx*.deb



Revision as of 15:26, 9 July 2015

Installing Proprietary Drivers a.k.a. Catalyst/fglrx

ATTENTION RADEON USERS

*PLEASE READ FIRST!

Which Radeon cards are no longer supported by ATI's Catalyst?

ATI Radeon 9500-9800, Xpress200-1250, 690G, 740G, X300-X2500, Mobility RadeonHD 2300 If your card is on that list, you are limited to open-source drivers on Ubuntu Lucid/10.04 (and later). NOTE: If you enter your card information on AMD/ATI's driver page, it will offer you the Catalyst 9-3 driver to download. However, the Catalyst 9-3 driver doesn't support X servers past 1.5, and it will not work with any modern/supported version of Ubuntu! !!!SO BE CAREFUL!!! If you tried to install Catalyst on a system with one of these cards, see the 'Removing the Driver' section to restore the default/pre-installed drivers.

ATI RadeonHD 2x00 - 4xx0 cards If you have one of these cards, you have the option of using the Catalyst Legacy driver, but you will need to install/use Ubuntu 12.04.1

I recommend copying and pasting the commands to ensure there are no typing mistakes and speed up the install process. Remember to use Ctrl + Shift + V or Shift + Insert to paste into the terminal (or go to the terminals menu, select edit and click paste).

Before you start

If you have previously attempted installing Catalyst, remove any leftover files by following the Removing the Driver section. Make sure universe and multiverse are enabled in your repository sources (System -> Administration -> Software Sources). or Applications->Ubuntu Software Center->Edit->Software sources->Other software: check canonical partners.

Install the prerequisite packages:

sudo apt-get install cdbs dh-make dkms execstack dh-modaliases linux-headers-generic libqtgui4 xserver-xorg-dev

If you are using the x86_64 architecture (64 bit):

sudo apt-get install lib32gcc1

Installing Catalyst Manually (from AMD/ATI's site) STABLE

Download the latest Catalyst package

This package contains both the 32-bit and 64-bit driver.

mkdir catalyst15.7 && cd catalyst15.7
wget --referer='http://support.amd.com/en-us/download/desktop?os=Linux+x86' http://www2.ati.com/drivers/linux/amd-driver-installer-15.20.1046-x86.x86_64.zip
unzip amd-driver-installer-15.20.1046-x86.x86_64.zip

Create and install .deb packages

If you have Wine installed, the driver installation may fail due to a conflict with a library included with Wine. In this case you'll need to modify the fglrx-core package before executing the second command below.

chmod a+x amd-driver-installer-15.20.1046-x86.x86_64.run
sudo ./amd-driver-installer-15.20.1046-x86.x86_64.run --buildpkg Ubuntu/trusty
sudo dpkg -i fglrx*.deb

If building .deb packages fails you can try an Alternative Manual Installation which does NOT create deb packages and might cause some trouble when trying to uninstall.

Installing Catalyst Manually (from AMD/ATI's site) BETA/EXPERIMENTAL

Note that the beta drivers aren't neccassarily newer than the stable drivers.

Download the latest Catalyst package

This package contains both the 32-bit and 64-bit driver.

mkdir catalyst-14.6beta1.0jul11 && cd catalyst-14.6beta1.0jul11
wget --referer='http://support.amd.com/en-us/download/desktop?os=Linux+x86' http://www2.ati.com/drivers/beta/linux-amd-catalyst-14.6-beta-v1.0-jul11.zip
unzip linux-amd-catalyst-14.6-beta-v1.0-jul11.zip
cd fglrx-14.20

Create and install .deb packages

sudo ./amd-driver-installer-14.20-x86.x86_64.run --buildpkg Ubuntu/utopic
sudo dpkg -i fglrx*.deb

If building .deb packages fails, there is also an Alternative Manual Installation

In case of failure

Remember these steps before you reboot your computer.

If the X server fails to start, switch to a new TTY using ctrl+alt+F2. Log in, and attempt to start the X server.

sudo startx

If it fails to start, you will likely see a stacktrace, and immediately above it will be something along the lines of "Could not stat /usr/lib64/fglrx/switchlibGL" which means that you failed to copy the executables properly. Ctrl+c, and immediately copy the switchlibGL and switchlibglx executables to the fglrx folder in /usr/lib64/ or /usr/lib32/.

If all else fails, revert your xorg.conf and reboot.

sudo cp /etc/X11/xorg.conf.orig /etc/X11/xorg.conf

This should return your original display.

Generate a new /etc/X11/xorg.conf file (DO IT AFTER INSTALLATION OF .DEB Packages)

Unfortunately, there is no sure way to generate the ATI version of the Xorg.conf file. It is entirely dependent on your configuration. The following subsections will attempt to address possible (and tested) variations for their respective configurations.

Generic Config

This will work for most people:

sudo amdconfig --initial -f

Minimal Config

A very basic /etc/X11/xorg.conf file might be what you need if you have a new card that's not fully supported by amdconfig. Here follows the entirety of a minimal xorg.conf file for the Radeon HD 6870:

Section "Device"
 Identifier "ATI radeon 6870"
 Driver "fglrx"
EndSection

Force use of the new xorg.conf (if necessary)

Some people find that changes to xorg.conf don't get used by the driver. To force the ATI driver to adopt changes made to xorg.conf, use the following command:

sudo amdconfig --input=/etc/X11/xorg.conf --tls=1

Test your installation

NOTE: if you don't reboot first, fglrxinfo gives an error message. Reboot the computer and type

fglrxinfo

into the terminal. If the vendor string contains AMD, you have installed the driver successfully. Using fglrxinfo on a system with Catalyst 12-3 and a RadeonHD 4550 returns:

display: :0.0  screen: 0
OpenGL vendor string: Advanced Micro Devices, Inc.
OpenGL renderer string: AMD Radeon HD 6670  --  (This line may be different depending on what graphics card you are using!)
OpenGL version string: 4.3.12798 Compatibility Profile Context 13.35.1005  --  (This line may be different depending on what graphics card and Catalyst version you are using!)

Now, try:

fgl_glxgears

If you experience issues or a hang, you may need to disable fast TLS.

sudo amdconfig --tls=0

Just in case

Write down or remember this series of Alt+PrntScr key combinations, just in case your screen should go black and Ctrl+Alt+F1 and Ctrl+Alt+Backspace doesn't work.

Alt+PrntScr+r, Alt+PrntScr+s, Alt+PrntScr+e, Alt+PrntScr+i, Alt+PrntScr+n, Alt+PrntScr+u, Alt+PrntScr+b

These key-presses will reboot the system safely. To remember the key-presses, remember this nonsensical phrase: "Raising Skinny Elephants Is Never Utterly Boring".

An alternative would be to hold down Ctrl+Alt+SysRq (SysRq is usually the same key as PrintScreen) and type very slowly R E I S U B. A way to remember this is by inverting the word: "BUSIER" or remembering a phrase: "Restart Even If System Utterly Broken". This would also safely shutdown the system.

Unity Desktop Freeze Problem

If your desktop environment randomly freezes, install a new one without compiz e.g. ubuntu-gnome-desktop

How to install Playonlinux/Wine without removig fglrx drivers

Edit this file: /var/lib/dpkg/status

search this block:

Package: fglrx-core
Status: install ok installed
Priority: extra
Section: restricted/misc
Installed-Size: 184704
Maintainer: Ubuntu Core Developers <ubuntu-devel-discuss@lists.ubuntu.com>
Architecture: amd64
Source: fglrx-installer
Version: 2:14.501-0ubuntu1
Replaces: fglrx-driver-core, libopencl1
Provides: fglrx-driver-core, libopencl1
Depends: libc6 (>= 2.3.4), libgcc1 (>= 1:4.1.1), libstdc++6 (>= 4.1.1), lib32gcc1, libc6-i386, dkms, make, linux-libc-dev
Conflicts: fglrx-driver-core, libopencl1
Conffiles:
 /etc/acpi/events/fglrx-ac-aticonfig 9b0805ac975ff3da6b76886a89dcc110
 /etc/acpi/events/fglrx-lid-aticonfig 63c597f0f7f6ac88887adc0c0ae00da9
 /etc/acpi/fglrx-powermode.sh c217d4dd7b677d7cf1fbf565f197b721
 /etc/OpenCL/vendors/amdocl64.icd 45a4b6c5182d693554c287765b369dfe
Description: Minimal video driver for the AMD graphics accelerators
 Minimal video driver for the AMD Radeon and FireGL graphics accelerators.
 .
 This package provides 2D display drivers.
Homepage: http://support.amd.com

and remove from provides and conflicts section libopencl1

result:

Package: fglrx-core
Status: install ok installed
Priority: extra
Section: restricted/misc
Installed-Size: 184704
Maintainer: Ubuntu Core Developers <ubuntu-devel-discuss@lists.ubuntu.com>
Architecture: amd64
Source: fglrx-installer
Version: 2:14.501-0ubuntu1
Replaces: fglrx-driver-core, libopencl1
Provides: fglrx-driver-core
Depends: libc6 (>= 2.3.4), libgcc1 (>= 1:4.1.1), libstdc++6 (>= 4.1.1), lib32gcc1, libc6-i386, dkms, make, linux-libc-dev
Conflicts: fglrx-driver-core
Conffiles:
 /etc/acpi/events/fglrx-ac-aticonfig 9b0805ac975ff3da6b76886a89dcc110
 /etc/acpi/events/fglrx-lid-aticonfig 63c597f0f7f6ac88887adc0c0ae00da9
 /etc/acpi/fglrx-powermode.sh c217d4dd7b677d7cf1fbf565f197b721
 /etc/OpenCL/vendors/amdocl64.icd 45a4b6c5182d693554c287765b369dfe
Description: Minimal video driver for the AMD graphics accelerators
 Minimal video driver for the AMD Radeon and FireGL graphics accelerators.
 .
 This package provides 2D display drivers.
Homepage: http://support.amd.com

after that install playonlinux

Get more fps in games

Change your cpu profile to performance:

cpufreq-set -g performance

This change is not permanent, to make it permanent write this line to /etc/rc.local before "exit 0" . If needet install the cpufreq package first.